Other - Safety Tester
よくあるご質問 閲覧ランキング
- 耐電圧（耐圧）試験って何ですか？
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示（PSEマーク）がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- What is the voltage phase at the beginning of the voltage curve of the AC withstanding voltage test performed by TOS series?
- What is the method of the high-voltage output circuit for Kikusui’s AC withstanding voltage testers?
- Why does TOS series detect a very small current (a few μA) when performing an AC withstanding voltage test without a DUT (only the test leads connected)?
- I have the AC/DC withstanding voltage tester of TOS series. What is the difference between an AC and DC withstanding voltage test?
- Why do I have to firstly connect the low-voltage test lead of TOS series?
- When unpacked and turned on the POWER switch of TOS series, the PROTECTION message lights on the front panel. What should I do?
- Can I resume the panel settings of TOS series?
- Why does the DANGER LED light on the stand-by TOS series tester in the rack system with several testers?
- Why is a DC voltage used for the insulation resistance test?
- Why is a withstanding voltage test necessary?
- Can I change an AC output frequency of TOS5101?
- Can I use the withstanding voltage testers of TOS series as a high-voltage power supply?
- Do I need a specific qualification to operate the withstanding voltage testers of TOS series?
- What is a leakage current?
- Why is an earth continuity tester necessary to measure a resistance between a protective conductor terminal or a protective grounding pin and a protective grounding part on a chassis?
- The voltage measurement cable has been broken during the earth continuity testing performed by TOS series (with the four-terminal wiring method). Does it affect the measurement result?
- What is the specification of the REMOTE connector on the front panel of TOS series?
- How can I conduct a withstanding voltage test on a three-phase input device?
- What is a good way to pre-inspect that the insulation resistance testers of TOS series properly determine the PASS or FAIL status?
- How do I calculate the resistance and power ratings of a dummy resistor required for the pre-inspection of TOS series?
- Is the pre-inspection for TOS series necessary?
- Do I need a specific qualification and facility to perform a calibration of TOS series?
- Can I calibrate TOS series by myself?
- Can I use a different test lead for TOS series than the supplied one?
- Is there a way to check other than short-circuiting between the test leads for TOS series to check whether they are broken?
