PXB Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- What is the inrush current of the PXB series?
- Is it necessary to connect the SENSING terminals when using local sensing on the PXB series?
- What is the allowable current of the optional three-phase input power cord for the PXB series?
- Is a power cord included with the PXB series?
- Does the current display differ between the master unit and slave units during parallel operation on the PXB series?
- Can different PXB series models be connected in parallel?
- Is the analog monitor output on the PXB series affected by the measurement trigger setting?
- What measured values are available from the analog monitor output of the PXB series?
- What measured values can be recorded on the PXB series?
- Does the PXB series support 200 Vac input or 400 Vac input?
- How should I use the M5 and M8 mounting holes on the DC OUTPUT terminal of the PXB20K-1000/1500?
- Can the PXB20K-500 output 525 V when the input voltage is 240 Vac?
- Can the input voltage of the PXB series be switched between 200 Vac and 400 Vac?
- How can I calculate the required input power capacity when using multiple PXB series units?
- Does the PXB series support source and sink operation in all operating modes?
- Can the PXB series handle motor back EMF?
- What happens when the output voltage reaches the CV setting while the PXB series is operating in CC mode?
- What happens when the output power reaches the CP setting while the PXB series is operating in CC mode?
- Why does the PXB series operate in CC mode even when CP is set?
- Is a connected capacitor discharged when the output is turned off on the PXB series?
- Can multiple PXB series units operate at the same time?
- Can I gradually increase the voltage setting from 0 V on the PXB series?
- Is there a difference between the setting value and displayed value on the PXB series?
- On the PXB series, does the output automatically turn on again when the OUTPUT OFF signal is released?
- When using CV control on the PXB series, do I still need to set the current and power?





