PCZ Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- I use PCZ1000A to an AC power supply (output: 100 Vac). While I am setting the CP mode to 1000 W and when the load current reaches 2.2 A, both the C.C and C.R LED blink and the load current can’t go up anymore. What should I do?
- Can be PCZ1000As with different firmware version connected in parallel?
- Which operation mode should I choose for PCZ1000A to simulate a load for a power conditioner: constant-current (CC) mode or constant-power (CP) mode?
- Do you have AC electronic loads?
- I connect five units of PCZ1000A in parallel and set the load current to 25 Arms, however the load current flows at only 5 Arms. What should I do?
- Can I use a PCZ1000A for testing on a three-phase AC power supply at 200 Vrms?
- I am performing the tracking operation with the three units of PCZ1000A to test a three-phase AC power supply. Why are the input powers different for each PCZ1000A unit?
- Does “Parallel Ope.” of the CONFIG setting of PCZ1000A include the master unit?
- Can I use PCZ1000A for an AC power supply at 24 Vrms?
- Why doesn’t the load current flow in PCZ1000A even when I turn the load on and set the load current setting?
- Is rack mounting bracket for PCZ1000A an accessory?